우리 ITExamDump사이트에서 제공되는CheckPoint인증156-315-71시험덤프의 일부분인 데모 즉 문제와 답을 다운받으셔서 체험해보면 우리ITExamDump에 믿음이 갈 것입니다. 우리ITExamDump의 제품을 구매하신다고 하면 우리는 최선을 다하여 여러분들한테 최고의 버전을 제공함으로 한번에CheckPoint인증156-315-71시험을 패스하도록 하겠습니다. IT시험이라고 모두 무조건 외우고 장악하고 많은 시간을 투자해야만 된다는 사상을 깨게 될 것입니다.
CheckPoint인증 156-315-71시험을 패스하여 자격증을 취득하는게 꿈이라구요? ITExamDump에서 고객님의CheckPoint인증 156-315-71시험패스꿈을 이루어지게 지켜드립니다. ITExamDump의 CheckPoint인증 156-315-71덤프는 가장 최신시험에 대비하여 만들어진 공부자료로서 시험패스는 한방에 끝내줍니다.
시험 번호/코드: 156-315-71
시험 이름: CheckPoint (Check Point Certified Security Expert R71)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 480 문항
업데이트: 2013-09-28
CheckPoint인증156-315-71시험은 현재 치열한 IT경쟁 속에서 열기는 더욱더 뜨겁습니다. 응시자들도 더욱더 많습니다. 하지만 난이도난 전혀 낮아지지 않고 이지도 어려운 시험입니다. 어쨌든 개인적인 지식 장악도 나 정보기술 등을 테스트하는 시험입니다. 보통은CheckPoint인증156-315-71시험을 넘기 위해서는 많은 시간과 신경이 필요합니다.
CheckPoint 인증 156-315-71시험에 도전해보려고 결정하셨다면 ITExamDump덤프공부가이드를추천해드립니다. ITExamDump덤프는 고객님께서 필요한것이 무엇인지 너무나도 잘 알고 있답니다. ITExamDump의 CheckPoint 인증 156-315-71덤프는CheckPoint 인증 156-315-71시험을 쉽게 만듭니다.
156-315-71 덤프무료샘플다운로드하기: http://www.itexamdump.com/156-315-71.html
NO.1 Which procedure creates a new administrator in SmartWorkflow?
A. Run cpconfig, supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
B. In SmartDashboard, click SmartWorkflow / Enable SmartWorkflow and the Enable SmartWorkflow
wizard will start. Supply the Login Name, Profile Properties, Name, Access Applications and Permissions
when prompted.
C. On the Provider-1 primary MDS, run cpconfig, supply the Login Name, Profile Properties, Name,
Access Applications and Permissions.
D. In SmartDashboard, click Users and Administrators right click Administrators / New Administrator and
supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
Answer: D
CheckPoint 156-315-71덤프 156-315-71
NO.2 Refer to Exhibit:
Match the ClusterXL Modes with their configurations
A. A-3, B-2, C-1, D-4
B. A-3, B-2, C-4, D-1
C. A-2, B-3, C-4, D-1
D. A-2, B-3, C-1, D-4
Answer: C
CheckPoint 156-315-71 156-315-71 156-315-71 pdf 156-315-71기출문제
NO.3 Which of the following commands can be used to stop Management portal services?
A. fw stopportal
B. cpportalstop
C. cpstop / portal
D. smartportalstop
Answer: D
CheckPoint pdf 156-315-71 dump 156-315-71
NO.4 What is a task of the SmartEvent Correlation Unit?
A. Add events to the events database.
B. Look for patterns according to the installed Event Policy.
C. Assign a severity level to an event
D. Display the received events.
Answer: B
CheckPoint 156-315-71 dump 156-315-71 156-315-71시험문제
NO.5 You want to verify that your Check Point cluster is working correctly. Which command line tool can you
use?
A. cphaconf state
B. cphaprob state
C. cphainfo-s
D. cphastart -status
Answer: B
CheckPoint기출문제 156-315-71 pdf 156-315-71 dumps 156-315-71 156-315-71 156-315-71 dump
NO.6 You need to publish SecurePlatform routes using the ospf routing protocol. What is the correct
command structure, once entering the route command, to implement ospf successfully?
A. Run cpconfig utility to enable ospf routing
B. ip route ospf
ospf network1
ospf network2
C. Enable
Configure terminal
Router ospf [id]
Network [network] [wildmask] area [id]
D. Use DBedit utility to either the objects_5_0.c file
Answer: C
CheckPoint시험문제 156-315-71덤프 156-315-71 156-315-71 156-315-71
NO.7 Which of the following statements about the Port Scanning feature of IPS is TRUE?
A. The default scan detection is when more than 500 open inactive ports are open for a period of 120
seconds.
B. The Port Scanning feature actively blocks the scanning, and sends an alert to SmartView Monitor.
C. Port Scanning does not block scanning; it detects port scans with one of three levels of detection
sensitivity.
D. When a port scan is detected, only a log is issued, never an alert.
Answer: C
CheckPoint자료 156-315-71기출문제 156-315-71 156-315-71 156-315-71
NO.8 How does a cluster member take over the VIP after a failover event?
A. Ping the sync interface
B. if list -renew
C. Broadcast storm
D. Gratuitous ARP
Answer: D
CheckPoint 156-315-71 156-315-71자격증 156-315-71
NO.9 What command will allow you to disable sync on a cluster firewall member?
A. fw ctl setsync 0
B. fw ctl sysnstat stop
C. fw ctl sysnstat off
D. fw ctl setsyns off
Answer: D
CheckPoint시험문제 156-315-71 156-315-71기출문제 156-315-71 156-315-71
NO.10 Which of the following manages Standard Reports and allows the administrator to specify automatic
uploads of reports to a central FTP server?
A. Smart Dashboard Log Consolidator
B. Security Management Server
C. Smart Reporter Database
D. Smart Reporter
Answer: D
CheckPoint 156-315-71시험문제 156-315-71 156-315-71 156-315-71
NO.11 You are establishing a ClusterXL environment, with the following topology: External interfaces
192.168.10.1 and 192.168.10.2 connect to a VLAN switch. The upstream router connects to the same
VLAN switch. Internal interfaces 172.16 10.1 and 172.16.10.2 connect to a hub. 10.10.10.0 is the
synchronization network. The Security Management Server is located on the internal network with IP
172.16.10.3. What is the problem with this configuration?
A. There is an IP address conflict
B. The Security Management Server must be in the dedicated synchronization network, not the internal
network.
C. The Cluster interface names must be identical across all cluster members.
D. Cluster members cannot use the VLAN switch. They must use hubs.
Answer: B
CheckPoint dump 156-315-71자격증 156-315-71
NO.12 Check point Clustering protocol, works on:
A. UDP 8116
B. UDP 500
C. TCP 8116
D. TCP 19864
Answer: A
CheckPoint최신덤프 156-315-71 156-315-71 156-315-71인증
NO.13 Organizations are sometimes faced with the need to locate cluster members in different geographic
locations that are distant from each other. A typical example is replicated data centers whose location is
widely separated for disaster recovery purposes.
What are the restrictions of this solution?
A. There are no restrictions.
B. There is one restriction: The synchronization network must guarantee no more than 150 ms latency
(ITU Standard G.114).
C. There is one restriction: The synchronization network must guarantee no more than 100 ms latency.
D. There are two restrictions: 1. The synchronization network must guarantee no more than 100ms
latency and no more than 5% packet loss. 2. The synchronization network may only include switches and
hubs.
Answer: D
CheckPoint 156-315-71 156-315-71
NO.14 When you check Web Server in a host-node object, what happens to the host?
A. The Web server daemon is enabled on the host.
B. More granular controls are added to the host, in addition to Web Intelligence tab settings.
C. You can specify allowed ports in the Web server's node-object properties. You then do not need to list
all allowed ports in the Rule Base.
D. IPS Web Intelligence is enabled to check on the host.
Answer: B
CheckPoint 156-315-71인증 156-315-71기출문제 156-315-71시험문제
NO.15 Which of the following is NOT a feature of ClusterXL?
A. Enhanced throughput in all ClusterXL modes (2 gateway cluster compared with 1 gateway)
B. Transparent failover in case of device failures
C. Zero downtime for mission-critical environments with State Synchronization
D. Transparent upgrades
Answer: C
CheckPoint덤프 156-315-71 156-315-71 156-315-71 pdf
NO.16 You are MegaCorp Security Administrator. This company uses a firewall cluster, consisting of two
cluster members. The cluster generally works well but one day you find that the cluster is behaving
strangely. You assume that there is a connectivity problem with the cluster synchronization cluster link
(cross-over cable).
Which of the following commands is the best for testing the connectivity of the crossover cable?
A. telnet <IP address of the synchronization interface on the other cluster member>
B. arping <IP address of the synchronization interface on the other cluster member>
C. ifconfig a
D. Ping <IP address of the synchronization interface on the other cluster member>
Answer: B
CheckPoint dumps 156-315-71 156-315-71최신덤프 156-315-71자료
NO.17 Control connections between the Security Management Server and the Gateway are not encrypted by
the VPN Community. How are these connections secured?
A. They are encrypted and authenticated using SIC.
B. They are not encrypted, but are authenticated by the Gateway
C. They are secured by PPTP
D. They are not secured.
Answer: D
CheckPoint 156-315-71 dumps 156-315-71덤프
NO.18 ________is a proprietary Check Point protocol. it is the basis for Check Point ClusterXL inter-module
communication.
A. RDP
B. CCP
C. CKPP
D. HA OPCODE
Answer: B
CheckPoint시험문제 156-315-71 156-315-71
NO.19 John is configuring a new R71 Gateway cluster but he can not configure the cluster as Third Party IP
Clustering because this option is not available in Gateway Cluster Properties: What's happening?
A. John is not using third party hardware as IP Clustering is part of Check Point's IP Appliance B .Third
Party Clustering is not available for R71 Security Gateways.
B. ClusterXL needs to be unselected to permit 3rd party clustering configuration.
C. John has an invalid ClusterXL license.
Answer: C
CheckPoint 156-315-71 156-315-71 156-315-71 dumps 156-315-71
NO.20 Which external user authentication protocols are supported in SSL VPN?
A. LDAP, Active Directory, SecurID
B. DAP, SecurID, Check Point Password, OS Password, RADIUS, TACACS
C. LDAP, RADIUS, Active Directory, SecurID
D. LDAP, RADIUS, TACACS, SecurID
Answer: B
CheckPoint자료 156-315-71 156-315-71 156-315-71인증
ITexamdump의 200-120덤프의 VCE테스트프로그램과 1Z0-511덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 000-156시험에 대비한 고품질 덤프와 642-384시험 최신버전덤프를 제공해드립니다. 최고품질 DC0-260시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기